it might look good, but it gives me so much crap

[Phantom]

so what do I have to do? turn up/down the inline reg? front reg?

[Jason Pryor]

Well you would want to lower the operating pressure. You can turn you reg down (lower the amount of air going into the gun). Since you don't have a gauge this makes it quite hard to determine how far is enough. Depending on the upgrades you should be able to operate an Autococker between 250 and 350 PSI. Anything over that is probaly going or is causing problems. I would turn your reg all the way out until your gun no longer fires. make sure your tank is screwed in. turn the reg up and after a few turns the gun should pressurize. If you have a chrono available I would keep turning the reg up a half a turn until your fps are where you want it to be. Remeber to shoot a couple of times after each adjustment on the reg to allow it to adjust and give you a proper reading. One other note, depending on the springs in your gun, you may want to have your velocity spring screwed in only 3-4 turns.

[throw_in_paint]

Its A Cocker Take It To Devon At Adren

[Tubyboy]

Ya it looks good and the reason if gives you so much crap is, it is a cocker, but I still like cockers. 😁